Allied Telesis AT-S63 - Manual (Page 376)

Chapter 22: IGMP Snooping Commands
376 Section III: IGMP Snooping, MLD Snooping, and RRP Snooping
SHOW IP IGMP
Syntax
show ip igmp [hostlist] [routerlist]
Parameters
hostlist Displays a list of the multicast groups learned by
the switch, as well as the ports on the switch that
are connected to host nodes. This parameter
displays information only when there are active
host nodes.
routerlist Displays the ports on the switch where multicast
routers are detected. This parameter displays
information only when there are active multicast
routers.
Description
This command displays the IGMP parameters. Figure 39 illustrates the
information that is displayed by this command without the optional
parameters.
Figure 39. SHOW IP IGMP Command
For an explanation of these parameters, refer to “SET IP IGMP” on
page 372.
An example of the information displayed by the HOSTLIST parameter is
shown in Figure 40.
Figure 40. SHOW IP IGMP Command with HOSTLIST Parameter
IGMP Snooping Configuration:
IGMP Snooping Status ............... Disabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum IGMP Multicast Groups ...... 64
Router Port(s) ..................... Auto Detect
Number of IGMP Multicast Groups: 1
MulticastGroup ......... 01:00:5E:00:01:01
VLAN ID ................ 1
Port/TrunkID ........... 6
HostIP .................
172.16.10.51
Version ................ v2
Time ..................... 21