Allied Telesis AT-S63 - Manual (Page 190)

Chapter 11: LACP Port Trunking Commands
190 Section I: Basic Operations
The PORT parameter displays LACP port information. Figure 18 illustrates
the information displayed by this parameter. For definitions, refer to the
IEEE 802.3ad standard.
Figure 18. SHOW LACP Command with the PORT Parameter
The AGGREGATOR parameter displays information about each existing
aggregator. Figure 19 illustrates the information displayed by this
parameter.
Figure 19. SHOW LACP Command with the AGGREGATOR Parameter
Examples
The following command displays general LACP status information:
show lacp
The following command displays the LACP configuration for ports 13 and
16:
show lacp port=13,16
Port ............. 05
Aggregator ....... LACP sw22
ACTOR
PARTNER
============================================
Actor Port ............. 05
Partner Port ......... 00
Selected ............... SELECTED Partner System ....... 00-30-84-AB-EF-CD
Oper Key ............... 0xf705 Oper Key ............ 0xff07
Oper Port Priority .... 0x0005 Oper Port Priority ... 0x0007
Individual ............. NO Individual ........... NO
Synchronized............ YES Synchronized.......... YES
Collecting ............ YES Collecting ........... YES
Distributing ........... YES Distributing ......... YES
Defaulted .............. NO Defaulted ............ NO
Expired ................ NO Expired .............. NO
Actor Churn .......... YES Partner Churn ........ YES
Aggregator # 1 ..... DEFAULT_AGG5
Admin Key .......... 0x0001
Oper Key ........... 0x0045
Speed .............. 1000 Mbps
Distribution Mode .. MACBoth
Ports configured ... 5-8
Ports in LAGID...... 5-8
Aggregated Port .... 5-8