Allied Telesis AT-S63 - Manual (Page 121)

121
Chapter 7
Port Parameter Commands
This chapter contains the following commands:
ˆ “ACTIVATE SWITCH PORT” on page 122
ˆ “DISABLE INTERFACE LINKTRAP” on page 123
ˆ “DISABLE SWITCH PORT” on page 124
ˆ “DISABLE SWITCH PORT FLOW” on page 125
ˆ “ENABLE INTERFACE LINKTRAP” on page 126
ˆ “ENABLE SWITCH PORT” on page 127
ˆ “ENABLE SWITCH PORT FLOW” on page 128
ˆ “PURGE SWITCH PORT” on page 129
ˆ “RESET SWITCH PORT” on page 130
ˆ “SET SWITCH PORT” on page 131
ˆ “SET SWITCH PORT FILTERING” on page 135
ˆ “SET SWITCH PORT RATELIMITING” on page 138
ˆ “SHOW INTERFACE” on page 141
ˆ “SHOW SWITCH PORT” on page 143
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information, refer to Chapter 6, “Port Parameters” in
the AT-S63 Management Software Menus Interface User’s Guide.