Allied Telesis AT-S63 - Manual (Page 500)

Chapter 28: Multiple Spanning Tree Protocol Commands
500 Section V: Spanning Tree Protocols
ˆ Maximum hop count
ˆ Force version of STP or normal MSTP
ˆ Configuration name
ˆ Revision level
Examples
The following command disables MSTP and returns all MSTP parameter
settings to their default values:
set mstp default
The following command sets the hop count to 10, the configuration name
to Engineering Region, and the reversion level to 2:
set mstp maxhops=10 configname="Engineering Region"
revisionlevel=2
The following command uses the FORCEVERSION parameter to
configure the bridge to use the MSTP parameters but to transmit only STP
BPDU packets:
set mstp forceversion=forcestpcompatible
Equivalent Command
purge mstp
For information, see “PURGE MSTP” on page 497. This command
performs the same function as the DEFAULT parameter.