Allied Telesis AT-S63 - Manual (Page 319)

AT-S63 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 319
QoS Command Sequence Examples
Creating a QoS policy involves a command sequence that creates one or
more classifiers, a flow group, a traffic class, and finally the policy. The
following sections contain examples of the command sequences for
different types of policies.
Example 1: Voice Application
Voice applications typically require a small bandwidth but it must be
consistent. They are sensitive to latency (interpacket delay) and jitter
(delivery delay). Voice applications can be set up to have the highest
priority.
This example creates two policies that ensure low latency for all traffic sent
by and destined to a voice application located on a node with the IP
address 149.44.44.44. The policies raise the priority level of the packets to
7, the highest level. Policy 6 is for traffic from the application that enter the
switch on port 1. Policy 11 is for traffic arriving on port 8 going to the
application.
Policy 6 Commands:
create classifier=22 description=”VoIP flow”
ipsadddr=149.44.44.44
create qos flowgroup=14 description=”VoIP flow”
priority=7 classifierlist=22
create qos trafficclass=18 description=”VoIP flow”
flowgrouplist=14
create qos policy=6 description=”VoIP flow”
trafficclasslist=18 ingressport=1
Policy 11 Commands:
create classifier=23 description=”VoIP flow”
ipdadddr=149.44.44.44
create qos flowgroup=17 description=”VoIP flow”
priority=7 classifierlist=23
create qos trafficclass=15 description=”VoIP flow”
flowgrouplist=17
create qos policy=11 description=”VoIP flow”
trafficclasslist=15 ingressport=8