Allied Telesis AT-S63 - Manual (Page 492)

Chapter 28: Multiple Spanning Tree Protocol Commands
492 Section V: Spanning Tree Protocols
CREATE MSTP
Syntax
create mstp mstiid= mstiid [mstivlanassoc= vids ]
Parameters
mstiid Specifies the MSTI ID of the spanning tree instance you
want to create. You can specify only one MSTI ID at a
time. The range is 1 to 15.
mstivlanassoc Specifies the VID of the VLAN you want to associate
with the MSTI ID. You can specify more than one VID at
a time (for example, 2,5,44).
Description
This command creates an MSTI ID and associates VLANs to the new
spanning tree instance.
The MSTIID parameter specifies the new MSTI ID.
The MSTIVLANASSOC parameter specifies the VIDs of the VLANs you
want to associate with the new MSTI. The VLANs must already exist on
the switch. If you do not specify any VLANs, you can add them later using
“ADD MSTP” on page 491 or “SET MSTP MSTIVLANASSOC” on
page 504.
Examples
The following command creates the MSTI ID 8 and associates to it the
VLAN with the VID 4:
create mstp mstiid=8 mstivlanassoc=4
The following command creates the MSTI ID 11 and associates to it the
VLANs with the VIDs 24 and 44:
create mstp mstiid=11 mstivlanassoc=24,44