Allied Telesis AT-S63 - Manual (Page 305)

AT-S63 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 305
SET SWITCH PORT PRIORITY OVERRIDEPRIORITY
Syntax
set switch port= port [priority= value ]
[overridepriority=yes|no|on|off|true|false]
Parameters
port Specifies the port you want to configure. You
can specify more than one port at a time, but the
ports must be of the same medium type. For
example, you cannot configure twisted pair and
fiber optic ports with the same command. You
can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both
(for example, 1,5,14-22).
priority Specifies a temporary priority level for all ingress
untagged packets received on the port. If you
include the OVERRIDEPRIORITY parameter,
the temporary priority level will also apply to all
ingress tagged packets. The range is 0 to 7; 0 is
the lowest priority, and 7 is the highest. The
default is 0.Table 11 on page 300 lists the
default mappings between the priority levels and
the egress queues:
overridepriority Determines if a port should ignore the priority
level in tagged packets and instead use the
temporary priority level assigned to the port with
the PRIORITY parameter. The options are:
yes, on, true Overrides the priority level in
tagged packets and uses the
temporary priority level. This is
the default. The options are
equivalent.
no, off, false Does not override the priority in
tagged packets. The options are
equivalent.
Description
This command can change a port’s temporary priority level. It can also be
used to determine whether a port receiving tagged packets should use the
priority level in the frames or instead use a temporary priority level
assigned to the port.