Allied Telesis AT-S63 - Manual (Page 341)

AT-S63 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 341
SET QOS PORT
Syntax
set qos port= value type=ingress|egress
policy= value |none
Parameter
port Specifies the port to which the policy is to be assigned or
removed. You can specify more than one port at a time if
the port is an ingress port of the traffic flow. Ports can be
identified individually (e.g., 5,7,22), as a range (e.g., 18-23),
or both (e.g., 1,5,14-22). You can specify only one port if
the port is functioning as an egress port for the flow.
type Specifies whether the port is an ingress or egress port for
the traffic flow of the policy. The default is ingress.
policy Specifies the policy to the assigned to the port. You can
specify only one policy. The NONE option removes the
currently assigned policy from a port.
Description
This command adds and removes ports from policies.
A port can be an ingress or egress port of only one policy at a time.
However, a port can be an ingress port and an egress port of different
policies, simultaneously. If a port is already a port of a policy, this
command automatically removes it from its current policy assignment
before adding it to another policy.
Examples
This command assigns QoS policy 12 to ingress ports 5 through 8:
set qos port=5-8 type=ingress policy=12
This command removes the currently assigned policy to egress ports 1
and 5:
set qos port=1,5 type=egress policy=none