Allied Telesis AT-S63 - Manual (Page 26)

Chapter 1: Starting a Command Line Management Session
26 Section I: Basic Operations
Starting a Command Line Management Session
The command line interface is supported from a local, Telnet, or SSH
management session of an AT-9400 Series switch. For instructions on
how to start a local or remote management session, refer to the AT-S63
Management Software Menus Interface User’s Guide.
The default management interface when you start a session is the
command line interface (CLI). The prompt differs depending on whether
you logged in as manager or operator. If you logged in as manager, you
will see “#.” If you logged in as operator, you will see “$.”
Note
Web browser interface does not support the command line interface.