Create snmpv3 targetaddr – Allied Telesis AT-S63 User Manual
Page 414
Chapter 25: SNMPv3 Commands
414
Section IV: SNMPv3
CREATE SNMPV3 TARGETADDR
Syntax
create snmpv3 targetaddr=
targetaddr
params=
params
ipaddress=
ipaddress
udpport=
udpport
timeout=
timeout
retries=
retries
taglist=
taglist
[storagetype=volatile|nonvolatile]
Parameters
targetaddr
Specifies the name of the SNMP manager, or host,
that manages the SNMP activity on the switch, up to
32 alphanumeric characters.
params
Specifies the target parameters name, up to 32
alphanumeric characters.
ipaddress
Specifies the IP address of the host.
udpport
Specifies the UDP port in the range of 0 to 65535.
The default UDP port is 162. This is an optional
parameter.
timeout
Specifies the timeout value in milliseconds. The
range is 0 to 2,147,483,647 milliseconds, and the
default is 1500 milliseconds. This is an optional
parameter.
retries
Specifies the number of times the switch resends
an inform message. The default is 3. This is an
optional parameter.
taglist
Specifies a tag or list of tags, up to 256
alphanumeric characters. Use a space to separate
entries. This is an optional parameter.
storagetype
Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile
Does not allow you to save the table
entry to the configuration file on the
switch. This is the default.
nonvolatile
Allows you to save the table entry to
the configuration file on the switch.
Description
This command creates an SNMPv3 Target Address Table entry.