Allied Telesis AT-S63 - Manual (Page 461)

461
Chapter 26
Spanning Tree Protocol Commands
This chapter contains the following commands:
ˆ “ACTIVATE STP” on page 462
ˆ “DISABLE STP” on page 463
ˆ “ENABLE STP” on page 464
ˆ “PURGE STP” on page 465
ˆ “SET STP” on page 466
ˆ “SET STP PORT” on page 469
ˆ “SET SWITCH MULTICASTMODE” on page 471
ˆ “SHOW STP” on page 473
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information on this feature, refer to Chapter 23,
“Spanning Tree and Rapid Spanning Tree Protocols” in the AT-S63
Management Software Menus Interface User’s Guide.