Allied Telesis AT-S63 - Manual (Page 220)

Chapter 14: File System Commands
220 Section II: Advanced Operations
file directly from the card. If at some point you remove the card and
reset the switch, the management software will not be able to find the
file and will instead use the switch’s default settings.
ˆ If the file is on a flash memory card, you must change to the directory
where the file is stored before performing this command. The
command does not accept a directory path. To change directories on a
flash card, see “SET CFLASH DIR” on page 218. The default location
is the root of the flash card.
Examples
The following command selects the file switch22.cfg as the new active
boot configuration file for the switch:
set config=switch22.cfg
The following command uses the NONE option to remove the current
active boot configuration file without specifying a new one. The switch
does not allow you to save any further changes to the switch’s
configuration. If you reset the unit, it uses the BOOT.CFG file to configure
its settings:
set config=none
The following command specifies the file “sw sales.cfg” on a flash memory
card as the switch’s active boot configuration file:
set config=cflash:”sw sales.cfg”