Allied Telesis AT-S63 - Manual (Page 296)

Chapter 18: Access Control List Commands
296 Section II: Advanced Operations
SHOW ACL
Syntax
show acl[= id_number ]
Parameters
acl Specifies the ID number of the ACL you want to view.
You can specify more than one ACL at a time.
Description
This command displays the ACLs on the switch. An example of the
information displayed by this command is shown in Figure 33.
Figure 33. SHOW ACL Command
The command displays the following information:
ˆ ACL ID - The ACL’s ID number.
ˆ Description - The description of the ACL.
ˆ Action - The action of the ACL. An active of Permit means that the
port(s) where the ACL is assigned accepts those packets that meet the
criteria of the classifiers. An action of Deny means that the port(s)
---------------------------------------------
ACL ID .............. 1
Description ......... IP
Action .............. Deny
Classifier List ..... 1
Port List ........... 2-3
Is Active ........... Yes
---------------------------------------------
ACL ID .............. 2
Description ......... Subnets 211, 214
Action .............. Permit
Classifier List ..... 2,3
Port List ........... 2
Is Active ........... Yes
---------------------------------------------
ACL ID .............. 3
Description ......... Subnet 211
Action .............. Permit
Classifier List ..... 3
Port List ...........
Is Active ........... No
---------------------------------------------