Allied Telesis AT-S63 - Manual (Page 538)

Chapter 30: GARP VLAN Registration Protocol Commands
538 Section VI: Virtual LANs
SET GARP TIMER
Syntax
set garp=gvrp timer [default] [jointime= value ]
[leavetime= value ] [leavealltime= value ]
Parameters
garp Specifies the GARP application you want to
configure. The only GARP application supported by
AT-S63 management software is GVRP.
default Returns the GARP timers to their default settings.
jointime Specifies the Join Timer in centiseconds, which are
one hundredths of a second. The default is 20 centi
seconds.
If you change this timer, it must be in relation to the
GVRP Leave Timer according to the following
equation:
Join Timer <= (2 x (GVRP Leave Timer))
leavetimer Specifies the LeaveTimer in centiseconds, which are
one hundredths of a second. The default is 60 centi
seconds.
leavealltime Specifies the LeaveAllTimer in centiseconds. The
default is 1000 centiseconds.
Note
The online help for this command contains an STP option. This
option is not supported.
Description
This command sets the GARP timers.
Note
The settings for these timers must be the same on all GVRP-active
network devices.