Allied Telesis AT-S63 - Manual (Page 284)

Chapter 17: Classifier Commands
284 Section II: Advanced Operations
SET CLASSIFIER
Syntax
set classifier= idnumber [description=” string ”]
[macdaddr= macaddress |any] [macsaddr= macaddress |any]
[priority= value ] [vlan= name |1..4094|any]
[protocol=ip|arp|rarp| number |any] [iptos= value |any]
[ipdscp= value |any] [ipprotocol= protocol | number |any]
[ipdaddr= ipaddress / mask |any] [ipsaddr= ipaddress /
mask |any] [tcpsport= value |any] [tcpdport= value |any]
[udpsport= value |any] [udpdport= value |any]
[tcpflags=[urg|ack|psh|rst|syn|fin|any]
Parameters
classifier Specifies the ID number of the classifier to be modified.
You can modify only one classifier at a time. The number
can be from 1 to 9999.
description Specifies a description of the classifier. A description can
be up to fifteen alphanumeric characters. Spaces are
allowed. If it contains spaces, it must be enclosed in double
quotes. Otherwise, the quotes are optional.
macdaddr Specifies a destination MAC address. The address can be
entered in either of the following formats:
xx:xx:xx:xx:xx:xx or xxxxxxxxxxxx
macsaddr Specifies a source MAC address. The address can be
entered in either of the following formats:
xx:xx:xx:xx:xx:xx or xxxxxxxxxxxx
priority Specifies the user priority level in a tagged Ethernet frame.
The value can be 0 to 7.
vlan Specifies a tagged or port-based VLAN by its name or VID
number.
protocol Specifies a Layer 2 protocol. Options are:
IP
ARP
RARP
You can specify additional Layer 2 protocols by entering
the protocol number in either decimal or hexadecimal
format. For the latter, precede the number with “0x”.