Disable lacp – Allied Telesis AT-S63 User Manual

Page 183

Text mode
Original mode

AT-S63 Management Software Command Line Interface User’s Guide

Section I: Basic Operations

183

DISABLE LACP

Syntax

disable lacp

Parameters

None.

Description

This command disables LACP on the switch. The default is disabled.

Caution

Do not disable LACP if there are defined aggregators without first
disconnecting all cables connected to the aggregate trunk ports.
Otherwise, a network loop may occur, resulting in a broadcast storm
and poor network performance.

Example

The following command disables LACP on the switch:

disable lacp

Equivalent Command

set lacp state=disable

For information, see “SET LACP STATE” on page 188.