Allied Telesis AT-SBx81CFC960 User Manual
Page 166
Chapter 8: Installing the Transceivers and Cabling the Ports
166
Section II: Installing the Chassis
Note
If you are ready to attach the fiber optic cable to the transceiver,
continue with the next step. Otherwise, repeat steps 1 to 3 to install
additional SFP+ transceivers in the card.
4. Remove the protective cover from the SFP+ transceiver, as shown in
Figure 106. Removing the Dust Cover from an SFP+ Transceiver in the
AT-SBx81CFC960 Controller Fabric Card
Note
The dust cover protects the fiber optic port on the SFP+ transceiver
from dust contamination. Do not remove it until you are ready to
connect the fiber optic cable.
5. Verify the position of the handle on the transceiver. If the transceiver is
in slot 1 or 3, the handle should be in the upright position, as shown in
Figure 107 on page 167. If the transceiver is in slot 2 or 4, the handle
should be in the down position.