Allied Telesis AT-SBx81CFC960 - Manual (Page 161)

SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Section II: Installing the Chassis 161
even numbered slot, position the connector so that the release tab is
on the bottom.
Figure 102. Installing the AT-SP10TW Cable in the AT-SBx81XS16 Line
Card
3. Install the other end of the cable into an SFP+ slot on another network
device.
4. Repeat this procedure to install additional AT-SP10TW Cables.
Note
To remove the connector and cable from the SFP+ slot, gently push
on the connector, pull on the release tab, and slide the connector
from the slot.
After installing the AT-SP10TW Cables, do one of the following:
 To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.
 After cabling all the ports in the chassis, go to Chapter 9,
“Powering On the Chassis” on page 169.
Release Tab
Release Tab