Allied Telesis AT-SBx81CFC960 - Manual (Page 164)

Chapter 8: Installing the Transceivers and Cabling the Ports
164 Section II: Installing the Chassis
Installing SFP+ Transceivers in the AT-SBx81CFC960 Card
The AT-SBx81CFC960 Controller Fabric Card has four slots for 10Gbps
SFP+ transceivers. The transceivers can be used for high-speed links to
network servers, switches, routers, or other network devices. A list of
supported SFP+ transceivers can be found on the Allied Telesis web site.
Note
The transceiver slots on the controller card do not support
1000Mbps SFP transceivers.
Note
Do not install transceivers in the SFP+ slots on the controller card if
yet you are building a stack with the VCStack Plus feature. The
stacking transceivers should be installed after you have configured
the chassis for stacking, as explained in Chapter 15, “Building a
Stack” on page 283.
To install a 10Gbps SFP+ transceiver in a transceiver slot in the controller
card, perform the following procedure:
1. Remove the dust plug from the slot chosen for the SFP+ transceiver.
Refer to Figure 103.
Figure 103. Removing a Dust Cover from an SFP+ Slot in the AT-
SBx81CFC960 Controller Fabric Card