Allied Telesis AT-SBx81CFC960 - Manual (Page 88)

Chapter 4: Safety Precautions and Site Requirements
88 Section II: Installing the Chassis
Installation Tools and Material
Here are the installation tools and material you need to have to install the
product.
Installing the chassis in an equipment rack requires the following items:
 #2 Phillips-head screwdriver
 Six equipment rack screws
 Flat-head screwdriver
 #2 Phillips-head 10 inch-lbs torque screwdriver (optional)
The grounding wire requires the following items:
 #2 Phillips-head screwdriver
 Crimping tool
 10 AWG stranded grounding wire
 #2 Phillips-head 20 inch-lbs torque screwdriver (optional)
The AT-SBxPWRSYS1 DC Power Supply requires the following items:
 Two 8 AWG power wires
 One 10 AWG stranded grounding wire
 8 mm wrench
 #1 Phillips-head screwdriver
 #3 Phillips-head screwdriver
 #3 Phillips-head 30 to 40 inch-lbs torque screwdriver (optional)
The AT-SBx81CFC960 Controller Fabric Card and Ethernet line cards
require the following items:
 #2 Phillips-head screwdriver
 #2 Phillips-head, 5 inch-lbs torque screwdriver (optional)