Allied Telesis AT-SBx81CFC960 - Manual (Page 213)

SwitchBlade x8106 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Section II: Installing the Chassis 213
3. Configure the VT-100 terminal or terminal emulation program as
follows:
 Baud rate: 115,200 bps
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow controller: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter. You are prompted for a user name and password.
5. Enter the default user name and password. They are “manager” and
“friend” (without the quotes), respectively
Note
User names and passwords are case sensitive.
The local management session starts and the command line interface
(CLI) prompt is displayed.
Entering the
AlliedWare Plus
Operating System
Commands
To confirm the operations of the chassis with the commands in the
AlliedWare Plus Operating System, perform the following procedure:
1. Enter the SHOW VERSION command in the User Exec or Privileged
Exec mode to display the software version number of the AlliedWare
Plus Operating System on the controller card, as shown in Figure 151.
Figure 151. SHOW VERSION Command
awplus# show version
AlliedWare Plus (TM) 5.4.4
Build name : SBx81CFC960-5.4.4.rel
Build date : Wed Dec 15 12:13:19 NZDR 2013
Build type : RELEASE
NEW-SNMP SNMP agent software
(c) 1996, 1998-2000 The Regents of the University of California.
All rights reserved;
.
.
.
Software Version
Number