Allied Telesis AT-SBx81CFC960 - Manual (Page 161)

SwitchBlade x8106 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Section II: Installing the Chassis 161
Note
The dust cover protects the fiber optic port on the transceiver from
dust contamination. It should not be removed until you are ready to
connect the fiber optic cable.
4. Before connecting the cable, verify the position of the handle on the
transceiver. If the transceiver is in an odd numbered slot, the handle
should be in the upright position, as shown in Figure 103. If the
transceiver is in an even numbered slot, the handle should be in the
down position.
Figure 103. Verifying the Position of the Handle on the Transceiver in the
AT-SBx81XS16 Line Card
5. Connect the fiber optic cable to the port on the transceiver, as shown
in Figure 104 on page 162. The connector should snap into the port.
Handle