beautypg.com

Allied Telesis AT-SBx81CFC960 User Manual

Page 264

background image

Chapter 13: Upgrading the Controller Fabric Card

264

Section II: Installing the Chassis

controller card. The name can be the same as or different from the
source filename. The filename must include the suffix “.cfg”.

This example of the command copies the Enginerring_sw1.cfg
configuration file from flash drive to the controller card:

copy usb:/Engineering_sw1.cfg Engineering_sw1.cfg

This example of the command copies the switch2a_rm12.cfg
configuration file from flash drive to the controller card, and renames it
Sales4_rm12.cfg:

copy usb:/switch2a_rm12.cfg Sales4_rm12.cfg

17. Move to the Global Configuration mode with the CONFIGURE

TERMINAL command:

awplus# configure terminal
awplus(config)#

18. Designate the file as the boot configuration for the chassis with the

BOOT CONFIG-FILE command in the Global Configuration mode.

The format of the command is given here:

boot config-file flash:/

filename

This example of the command designates the configuration file
Engineering_sw1.cfg as the boot configuration file for the chassis.

boot config-file flash:/Enginerring_sw1.cfg

19. Enter the EXIT command to return to the Privileged Exec mode.

awplus(config)# exit
awplus#

20. Enter the REBOOT command in the Privileged Exec mode to reboot

the chassis.

awplus# reboot

21. Enter Y for yes at the confirmation prompt.

22. Wait three minutes for the controller and Ethernet line cards to initialize

the management software.

23. Start a new management session and use the appropriate SHOW

commands to confirm the configurations of the components and
features of the chassis.

24. To install optional feature licenses, use the LICENSE command in the

Privileged Exec mode of the command line interface. For instructions,

This manual is related to the following products: