Campbell Scientific CR10X Measurement and Control System - Manual (Page 73)

SECTION 5. TELECOMMUNICATIONS
5-3
TABLE 5.1-1. Telecommunications Commands
Command Description
[F.S. Area]A SELECT AREA/STATUS - If 1 or 2 does not precede the A to select
the Final Storage Area, the CR10X will default to the Area last used
(initially this is Area 1). All subsequent commands other than A will
address the area selected. Datalogger returns Reference, the DSP
location; the number of Filled Final Storage locations; Version of
datalogger; Final Storage Area; Location of MPTR (the location
number may be 1 to 7 characters long); Errors #1, #2, and #3 where
#1 is the number of E08's, #2 is the number of overrun errors, and
#3 is the number of times the program stopped due to low voltage
(all are cleared by entering 8888A; #2 is also cleared at time of
program compilation); size of total Memory in CR10X in Kbytes; the
lithium Battery voltage; and Checksum. All in the following format:
R+xxxxx. F+xxxxx. Vxx Axx L+xxxxxxx. Exx xx xx Mxxxx B+x.xxxx Cxxxx
If data is stored while in telecommunications, the A command must
be issued to update the Reference to the new DSP.
[no. of arrays]B BACK-UP - MPTR is backed-up the specified number of Output
Arrays (no number defaults to 1) and advanced to the nearest start
of array. CR10X sends the Area, MPTR Location, and Checksum:
Ax L+xxxxxxx Cxxxx
[YR:DAY:HR:MM:SS]C RESET/SEND TIME - If time is entered the time is reset. If only 2
colons are in the time string, HR:MM:SS is assumed; 3 colons
means DAY:HR:MM:SS. If only the C is entered, time is unaltered.
CR10X returns year, Julian day, hr:min:sec, and Checksum:
Yxx Dxxxx Txx:xx:xx Cxxxx
[no. of arrays]D ASCII DUMP - If necessary, the MPTR is advanced to the beginning
of the next array. CR10X sends the number of arrays specified (no
number defaults to 1) or the number of arrays between MPTR and
Reference, whichever is smaller, CRLF, FSA, Location, Checksum.
E End call. Datalogger sends CRLF only.
[no. of loc.]F BINARY DUMP - Used by CSI software for data retrieval. See
Appendix C.
[F.S. loc. no.]G MOVE MPTR - MPTR is moved to specified Final Storage location.
The location number must be entered. CR10X sends Area,
Location, and Checksum:
Ax L+xxxxxxx Cxxxx
7H or 2718H REMOTE KEYBOARD - CR10X sends the prompt ">" and is ready
to execute standard keyboard commands (Section OV3).