Campbell Scientific CR10X Measurement and Control System - Manual (Page 305)

TD ADDENDUM
 SECTION 1. FUNCTIONAL MODES
AD-1-7
TABLE 1.8-14. Set PakBus Neighbors
Key
Entry
Display Comments
*D 13:00 Enter Command
19A 19:00 Port (17- SDC7, 18 – SDC8, 02
– CSI/O, 02—CR23X RS232
port, 9600 baud
A 19:0000 Interval in seconds of the
expected rate of
communication. A neighbor is
aged after 2.5 times this
interval and the Hello attempt
will be reinitiated.
A 01:xxxx PakBus Address of neighbor
A 01:xx Swath of neighbors with
sequential addresses starting
with above address.
A 02:xxxx PakBus Address of neighbors
A 02:xx Swath of neighbors with
sequential addresses starting
with above address.
... etc.
A nn:0000 Terminates the list.
1.9 *9 DATA TABLES SIZES.
The *9 Mode is used to view the sizes of the
Data Storage Tables (section 2.1) created by
the datalogger program (*1, *2, or *3). The *9
Mode will also display how long until any
automatically allocated Data Storage Tables fill.
All Data Storage Tables are in a ring
configuration such that the oldest records are
overwritten by new records once the table is full.
The sizes are given as the number of records.
A record can be thought of as a row of data
where each field (i.e., column) is a data value
associated with an Output Processing
Instruction. The order and number of fields in a
Data Table are determined by the Output
Processing Instructions following the Data Table
Instruction. The tables are numbered in the
order the Data Table Instruction appear in the
Program Tables, *1 first, *2 second, and *3 last.
TABLE 1.9-1. Description of * 9 Data
Keyboard Display
Entry ID: Data Description
*9 09:xx Number of tables/ Enter table number to jump to that table or 0
to see next parameter.
0A 00:x.xxxx Days before any automatically allocated table fills.
A 01:xxxxx. Number of records in table 01
A 02:xxxxx Number of records in table 02
A nn:xxxxx. Number of records in table nn