Campbell Scientific CR10X Measurement and Control System - Manual (Page 64)

SECTION 3. INSTRUCTION SET BASICS
3-10
30 Compile IF and/or LOOP nested
too deep
31 Run Time SUBROUTINES nested
too deep
32 Compile Instruction 3 and interrupt
subroutine use same port
33 Compile Cannot use Control Port
6 as counter or interrupt
subroutine with
Instruction 15 or SDM or
SDI-12 input/output
instructions
40 Editor Instruction does not exist
41 Editor Incorrect execution
interval
60 Compile Insufficient Input Storage
61 Compile Burst Measurement Scan
Rate too short
62 Compile N<2 in FFT
68 Compile Instruction 118 without
enough Instructions 68 or 63
92 Compile Instruction 92, intervals in
seconds: Time into Interval
> 59 or Interval > 60
94 ∗D MODE Program Storage Area
full
95
∗D MODE
Program does not exist in
Flash memory
96
∗D MODE
Addressed device not
connected or wrong
address (see Table 1.8-2)
97
∗D MODE
Data not received within
30 seconds
98
∗D MODE
Uncorrectable errors
detected
99 ∗D MODE Wrong file type or editor
error