Horner APG XL4 OCS HE-ETN300 - Manual (Page 79)

SUP0740-07 CH.12
11/30/2009 Page 79 of 98 # 958
CHAPTER 12: Email (SMTP Protocol)
12.1 Overview
Electronic mail, often abbreviated as email or e-mail, is a method of exchanging digital
messages, designed primarily for human use. Email has been implemented using SMTP (Simple
Mail Transfer Protocol) protocol in OCS.
An electronic mail message consists of two components, the message header, and the message
body, which is the email's content. The message header contains control information, including,
an originator's email address and one or more recipient addresses. Usually additional information
is added, such as a subject header field.
This feature is designed to send email messages embedding real time data (logic registers) of the
controllers and can be configured using Cscape.
Minimum version requirements for Email feature:
1. Firmware 12.6
2. Cscape 9
Refer Quick Start Guide (MAN0923) for stepwise configuration details.
This feature is available only in OCS that have inbuilt ethernet port like the NX, QX and XL6e.
This feature:
- Supports login type authentication (TSL/SSL authentication servers are not supported)
- Allows upto 20 logic registers to be embedded per email.
- Supports upto 128 different emails to be configured.
NOTE: OCS sends emails without attachments and cannot receive emails.
12.2 Email Configuration:
Ethernet port configuration in Ethernet System Requirements and Interoperability is needed
before configuring Email feature.
Open Cscape and then Email Configuration dialog, Click on Program and then select
Messaging | Email.
This will bring up the following dialog.