Horner APG XL4 OCS HE-ETN300 - Manual (Page 16)

CH.3 SUP0740-07
11/30/2009 Page 16 of 98 # 958
Figure 3-2– Hardware Configuration Dialog – OCS Models With User-Installable Ethernet
3. To configure a user-installable Ethernet Module into a SmartStack I/O slot, do the following:
a. Referring to Figure 3.2 above, click on the Config button to the right of the desired I/O
slot, which will open the Add I/O Module dialog, as shown in Figure 3.3.
b. Click the Comm tab and select the desired HE800ETNxxx item from the list.
c. Click OK. The Ethernet Module is now configured into an I/O slot, as shown in Figure 3.4.
Note: Normally, a user-installed Ethernet Module occupies the first I/O slot on the back of the
OCS or RCS unit. The only exception to this rule occurs if a FOX100 Module is also
installed. In this case, the FOX100 Module occupies the first I/O slot, and the Ethernet
Module is installed into the second I/O slot.
Caution: For proper functioning and to avoid possible damage, do not install more than
four SmartStack Modules on the back of an OCS or RCS controller.