Horner APG XL4 OCS HE-ETN300 - Manual (Page 20)

CH.3 SUP0740-07
11/30/2009 Page 20 of 98 # 958
As with the IP Address register (described in the Standard Configuration section
below), Net Mask and Gateway register Directions can be set to Read Only or Read
/ Write
With Cscape 8.2 onwards, the ETN Module Configuration dialog has been enhanced
to support the following:
1. More easily expanded Protocol Support list for current and future
protocols.
2. Optional Enhanced Configuration:
a. Allows Net Mask and Gateway to be optionally read from or written
to OCS registers.
b. Allows all OCS register assignments to be optional instead of
mandatory.
Ethernet Module Configuration Dialog Rules
The following rules describe how the new Ethernet Module Configuration Dialog is to
be used:
I. The Enhanced Configuration checkbox will be unchecked and grayed if
configuring an ETN100 or ETN116 Module.
II. If the Enhanced Configuration checkbox is checked, Cscape will display an
error message and will abort an I/O Configuration download if:
A. Configuring an ETN200 or ETN300 Module with ETN Firmware < 4.35,
B. Configuring an OCS, QX or NX with Engine Firmware < 11.91.
III. If the Enhanced Configuration checkbox is unchecked, the dialog maintains
backward compatibility as follows:
A. The Net Mask and Gateway Register edit boxes will be empty and
grayed.
B. The Net Mask and Gateway Direction combo boxes will be empty and
grayed.
C. All other dialog objects function the same as in the Cscape 8.0b dialog,
except as follows:
1. The new IP Address Direction combo box replaces the old Get IP
from IP Addr Register checkbox. A Direction of Read Only, is
equivalent to unchecked and a Direction of Read / Write is equivalent
to checked.
2. The new Protocol Support area contains a protocol list box showing
the protocols supported by the platform being configured. Each
protocol in the list box has a checkbox in front of it that can be checked
to enable the protocol. The single Config Selected Protocol button
applies to the protocol that is currently highlighted in the list box.
Standard Configuration
To perform Standard Configuration, simply leave the Enhanced Configuration
checkbox unchecked.
In this case, Net Mask and Gateway cannot be assigned to OCS registers, while IP
Address, Status and Version must be assigned to OCS registers.