Horner APG XL4 OCS HE-ETN300 - Manual (Page 44)

CH.6 SUP0740-07
11/30/2009 Page 44 of 98 # 958
Figure 6.10– Configured Produced Exchange 1 - Node 1
4. Now that Exchange 1 has been configured as a Produced Exchange for Node 1, it is time to
configure Exchange 2 as a Consumed Exchange for Node 1. To do this, first select the
Consumed Exchanges tab (Figure 6.2) and click on the Add Exch button to create a
Consumed Exchange. Then fill in the parameters, as shown in Figure 6.11 below, and click
OK.
In this example, Node 1 will be the only Consumer to receive Exchange 2 from Node 2 and
will not be a member of a Group of Consumers. Also, the Update Timeout is set to 410, which
means Node 1 will expect to receive Exchange 2 from Node 2 at least every 410 mS. Note
this is twice the time, plus 10 mS, that Node 2 will be configured to transmit Exchange 2 as
recommended in Table 6.1.