Outback Power Systems FLEXmax 80 Owners Manual - Manual (Page 83)

MATE/MATE2 Screens
900-0009-01-00 Rev C 81
AUX Menu
Figure 90 ADV Menu for the AUX Features
Navigation for ADV/CC/AUX
 moves to the next menu item in
the diagram.
 increases the value of the selection.
 decreases the value of the selection.
 directs the MATE to read the next
device (port) on the HUB.
 returns to the CC/PAGE2 screen.
 returns to the choose device screen.

returns to the main menu (see page 77).
CC/AUX
The AUX screens adjust the same settings that
are available on the Aux screen in the FLEXmax
(see page 27).
AUX mode:
 vent fan
 pv trigger
 error output
 night light
 float
 diversion: relay
 diversion: solid st
 low batt(ery) disconnect
 remote
The remote mode also can be used for the
MATE’s AGS function. See page 41.
NOTE: The AGS function is only intended for use
in systems with a HUB, inverter, and FLEXmax. If
the MATE connects only to a FLEXmax, the only
AGS function that will work is the DC genset
programming. The other AGS functions will not
work properly.
NOTE: The MATE must have firmware revision
4.1.6 or higher for AGS to work.
aux control
 ON
 OFF