Outback Power Systems FLEXmax 80 Owners Manual - Manual (Page 39)

Operation
900-0009-01-00 Rev C 37
Diversion:Solid St (AUX Mode)
Figure 26 Setting the Diversion:Solid St AUX Mode (Part 1)
IMPORTANT
:
 If using wind or hydroelectric turbines,
keep the charge controller’s diversion
voltage slightly above its Absorb and Float
voltage settings for efficient functioning.
 Do not use Diversion:Solid St with a
mechanical relay. The PWM action could
cause irregular relay activity.
 Diversion:Solid St requires the use of a
purely resistive load. The PWM action may
work poorly with mechanical loads.
To set the mode for Diversion:Solid St:
1. From the main menu, press <> or <> to move the  to the
left of Aux.
2. Press to open the AUX MODE screen.
3. Press until the Diversion:Solid St mode is displayed in
the AUX MODE screen.
4. Press to cycle through ON, OFF, or AUTO.
 ON activates the AUX output.
 OFF deactivates the AUX output.
 AUTO controls the output according to the criteria of the
selected AUX mode.
Continued on next page...
Charger Aux Light
EQ Misc Advanced
Logging Stats
EXIT
  GO
Main Menu
Charger
Aux
Light
EQ Misc Advanced
Logging Stats
EXIT
  GO
AUX MODE 
Diversion:Solid St
Output: Off Off
EXIT NEXT SET MODE
proceeds to the
next AUX MODE screen.