Outback Power Systems FLEXmax 80 Owners Manual - Manual (Page 18)

Operation
16 900-0009-01-00 Rev C
Version and/or Voltage Setting Screens
Once the password has been entered, the display will return to the Select Version screen.
Figure 10 Changing the Version Setting
To change the version:
1. Press or to cycle through the version
choices of:
 English,
 Australian, or
 Espanola.
2. When the desired version is displayed, press or
to proceed to the confirmation screen.
3. Press to confirm the selection.
The SYSTEM VOLTAGE screen appears next.
The FLEXmax automatically detects the system’s battery voltage
and indicates it by placing two ^^ symbols below the value.
 If the value indicated is correct, press .
 If the value indicate is not correct for the present system,
press <> to move the ^^ to below the correct voltage.
 Press to confirm the selection.
The Status screen is the last screen to be displayed after startup.
The soft keys below the Status screen navigate to the main
menu and the End-of-Day summary screen. See page 17 for
details on the Status screen.
Select Version
Elija la Version
English
NEXT ENTER ENTRA SEL
Select Version Screen
SYSTEM VOLTAGE
12 24 36 48 60
^^
 ENTER
SYSTEM VOLTAGE Screen
Are you sure?
English
NO YES
Confirmation Screen
Select Version
Elija la Version
English
NEXT ENTER ENTRA SEL
Select Version Screen
or
In 11.6V 0.0 A
Out 13.8V 0.0 A
0.000 kW 0.0 kWH
AUX: OFF Sleeping
Status Screen
Are you sure?
12 24 36 48 60
^^
NO YES
Verification Screen
or