Outback Power Systems FLEXmax 80 Owners Manual - Manual (Page 103)

Applications
900-0009-01-00 Rev C 101
Figure 102 Adjusting Range Limits for Hydroelectric or Fuel-cell Applications
Charger Aux Light
EQ Misc Advanced
Logging Stats
EXIT
  GO
Main Menu
Charger Aux Light
EQ Misc Advanced
Logging Stats
EXIT
 
GO
ADV SETUP Screen
ADVANCED MENU
MPPT Mode
Auto Track
EXIT NEXT nonGT MODE
MPPT Mode (Auto Track)
To adjust the Lower Mpp Range Limit:
1. From the main menu, press <> to move the arrow next to
the Advanced function.
2. Press .
3. In the ADVANCED MENU screen, press again to
display the Mpp Range Limit % Voc screen.
4. Press <1/2> until FULL appears.
5. When finished, press until the MPPT Mode
screen appears.
ADVANCED MENU
Park Mpp
Watts 0251 77 % Voc
EXIT NEXT -% +%
U-pick% (Voc) MPPT
ADVANCED MENU
Mpp Range Limit %VOC
Min Max
EXIT NEXT 1/2 90%
Mpp Range Limit % Voc
ADVANCED MENU
Snooze Mode
< 0.6 amp
EXIT NEXT AMP
To pick between Auto Track or U-Pick % MPPT Mode and determine the
charge controller’s operating Voc percentage, press to interchange
between the two modes.
Re-entering the password might be required. After choosing a mode, press
in the ADVANCED MENU to view the Park Mpp screen (only
applicable for U-Pick mode).
Press < -%> or <+%> to select one of the percentage values; U-Pick always
uses the Park Mpp value.