Outback Power Systems FLEXmax 80 Owners Manual - Manual (Page 48)

Operation
46 900-0009-01-00 Rev C
Advanced Menu
The Advanced menu allows fine-tuning of the FLEXmax operations including Snooze periods and
Maximum Power Point limits (see page 95). The following modes are available in the Advanced menu.
They will appear in the following order.
 Snooze Mode
 Wakeup
 MPPT Mode
 Park Mpp
 Mpp Range Limit % Voc
 Absorb Time
 Rebulk Voltage
 Vbatt Calibration
 RTS Compensation
 Auto Restart
 Aux Polarity
 Reset to Defaults?
Figure 35 Accessing the Advanced Menu
Snooze Mode (Advanced Menu)
Snoozing occurs if the charging current does not reach the user-selected cutoff current set point as
shown in this screen.
Figure 36 Snooze Mode
To adjust the set point in the Snooze Mode screen:
1. Navigate to the Snooze Mode screen through the
ADVANCED MENU as instructed in Figure 35.
2. Press to adjust the amp setting.
Amp values increments include: 0.2, 0.4, 0.6, 0.8 and 1.0.
3. Press to advance to the Wakeup Mode screen.
To Exit:
 Press once to return to the main menu.
 Press twice to return to the status screen.
ADVANCED MENU
Snooze Mode
< 0.6 amp
EXIT NEXT AMP
Snooze Mode
To Access the Advanced Menus:
1. From the main menu, press <> or <> to move the

to the left of Advanced.
2. Press to open the first Advanced menu screen.
3. Press to cycle through the available modes. The
Snooze Mode screen should be the first screen to display.
4. Press to return to the status screen.
Charger Aux Light
EQ Misc Advanced
Logging Stats
EXIT
  GO
Main Menu
Charger Aux Light
EQ Misc Advanced
Logging Stats
EXIT   GO