HP Designjet 5100 Printer series - Manual (Page 78)

5-10
Front-panel messages
HP Designjet 5100 printer Customer Reference Guide
Printhead status messages
See Status code interpretation, on page 2 .
Status code
XX ranges from
00 - 55
Printhead message
description
Procedure
XX02 Reseat
XX06 Reseat
XX08 Reseat The printhead may only be
badly seated. This means there
is a bad electrical connection
between the printhead and the
printer carriage.
Try these steps below. If the message
returns to OK after performing the first
step, do not continue.
1. Remove the printhead and insert the
printhead again.
2. Remove the printhead and clean the
interconnect, refer to carriage
interconnect wiper, on page 56.
3. Replace the printhead.
XX10 Reseat There is an electrical failure.
XX03 Replace Printhead smart chip failure. Replace printhead.
XX04 Replace
XX05 Replace You have installed a new tubes
system and the printer is
priming them. The printer has
detected that the setup
printheads are still installed.
Remove the used setup printhead(s)
and replace with normal ones.
XX09 Replace There is an electrical failure. Remove the printhead(s).
XX11 Replace The printer has detected that
you have installed an incorrect
type of printhead.
Ensure that you have HP 705
printheads installed.
XX12 Replace
The printer detects that the
printhead does not match the
rest of the ink consumable
items.
Ensure that all the ink consumable
items are HP 705.