HP Designjet 5100 Printer series - Manual (Page 75)

5-7
Front-panel messages
HP Designjet 5100 printer Customer Reference Guide
Receiving The printer is receiving a file. If you have problems printing refer to
the “Using Your Printer CD”.
Receiving Low
memory
While receiving a print file, the
printer’s memory has become
low.
The printer will compress the file while
it continues to receive the data.
XXXX Recover There is a problem with one of
the printheads you are using.
To see which printhead has the
problem, go to the printhead
menu and press Enter.
See printhead recovery procedure, on
page 38 for details.
Remove ink
cartridge by
pushing it in and
up
This is an ink cartridge
removal instruction.
See 67, in section maintain the ink
system on the reverse of this guide.
Remove media
weight
Wind excess
media using TUR
button
Press ENTER
When you are unloading a
roll from the printer, you must
remove the media weight from
the take-up reel before you can
complete the procedure.
If you do not want to use the take-up
reel, you can turn off the setting by
going to Utilities > TUR installed > No
XXXX Replace A printhead needs to be
replaced.
See Printhead status messages, on
page 10 .
Replace cleaner The printer is designed so that
when you replace a printhead
you must also replace the
printhead cleaner.
See 80, in section maintain the ink
system on the reverse of this guide for
details.
Replace ink
cartridge
This is an ink cartridge
removal instruction.
See 67, in section maintain the ink
system on the reverse of this guide.
Reset Web Passwd This is displayed when you are
resetting your WebAccess
password.
Setup The setup message is
displayed when new tubes
have been installed into the
printer and you have installed
the correct setup printheads
When the setting-up of the tube system
is complete, the front panel will
display a message asking you to
remove the setup printheads and
replace with ‘normal’ printheads.
Status Description Procedure