HP Designjet 5100 Printer series - Manual (Page 74)

5-6
Front-panel messages
HP Designjet 5100 printer Customer Reference Guide
Misalignment This means that the printing
material has not been fed into
the printer straight.
Reload the printing material, making
sure that the edges are parallel and
that it is straight when you feed it in.
Align the material coming out from the
printer with the material going into the
printer, see 34, in section load and
unload material on the reverse of this
guide.
Misposition The printing material is not
positioned correctly in the
printer. It may be too far to the
left or the right.
Check that you have loaded the
printing material correctly as shown in
the procedure 34, in section load and
unload material on the reverse of this
guide.
No media profile
available.
The printer cannot find the
internal media profile.
Unload any printing material in the
printer and switch the printer off using
the switch at the back. Switch on
again. If the problem persists, call
your support representative.
OK The ink system is working
correctly
Preparing
printheads
Your printer is servicing the
printheads to maintain
optimum print quality.
Preventative
maintenance
advised
The printer has kept track of
the number of cycles your
printer has performed. This
message means the printer
needs maintenance to
maintain its performance and
to prevent printer down-time in
the future.
Contact your support representative.
Arrange a time that would be
convenient for you and he will service
the printer. See the “Using Your
Printer” CD.
Printer temperature
is out of the
printer's operating
range. Printer
cannot function.
Under cold environmental
conditions outside its
operating range the printer
will stop. It does this to protect
the ink systems inside the
printer.
Simply ensure the temperature is
above 15 °C and turn the printer off
and on again.
Printing Low
memory
The printer previously
compressed a print file while
receiving it, and it is now
expanding the file.
Printing will continue after expanding
the data, but it will be slower than
usual.
Processing The printer has received a
print file and is processing the
information before starting to
print.
Status Description Procedure