HP IP Distance Gateway - Manual (Page 92)

Ping command
Verifies the connectivity of each Ethernet port: management, GE1 (iSCSI 1), and GE2 (iSCSI 2).
Admin session Authority
ping Syntax
mpx239 (admin) #> ping
A list of attributes with formatting and current values Example
will follow.
Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or
'Q' and the ENTER key to do so.
IP Address (IPv4 or IPv6) [0.0.0.0] 44.44.1.240
Iteration Count (0=Continuously) [0 ] 10
Outbound Port (0=Mgmt, 1=GE1, 2=GE2, ...) [Mgmt ] 1
Size Of Packet (Min=1, Max=62256 Bytes) [56 ] 62256
Pinging 44.44.1.240 with 62256 bytes of data:
Reply from 44.44.1.240: bytes=62264 time=109.0ms
Reply from 44.44.1.240: bytes=62264 time=108.5ms
Reply from 44.44.1.240: bytes=62264 time=108.5ms
Reply from 44.44.1.240: bytes=62264 time=108.5ms
Reply from 44.44.1.240: bytes=62264 time=108.5ms
Reply from 44.44.1.240: bytes=62264 time=108.6ms
Reply from 44.44.1.240: bytes=62264 time=108.5ms
Reply from 44.44.1.240: bytes=62264 time=108.4ms
Reply from 44.44.1.240: bytes=62264 time=108.5ms
Ping Statistics for 44.44.1.240:
Packets: Sent = 10, Received = 9, Lost = 1
Minimum = 108.4ms, Maximum = 109.0ms, Average = 108.5ms
mpx239 (admin) #>
Quit command
Exits the CLI and returns the operator to the login prompt.
Admin session Authority
quit Syntax
The following is an example of the quit command: Example
mpx110 (admin) #> quit
(none) login:
Reboot command
Restarts the mpx110 firmware.
Admin session Authority
reboot Syntax
The following is an example of the reboot command: Example
mpx110 (admin) #> reboot
Are you sure you want to reboot the System (y/n): y
System will now be rebooted...
92 Command-line interface