HP IP Distance Gateway - Manual (Page 125)

Table 27 iSCSI driver—Error log messages (continued)
Description No. Log message ID
The driver failed to receive a
heartbeat from the iSCSI 928 #%d: QLReadyTimer: Adapter missed heartbeat for %d seconds.
Time left %d 74656
processor for the specified
number of seconds.
Driver did not receive a heartbeat
event from iScsi FW 931 #%d: QLReadyTimer: Adapter missed heartbeat for 0x%x seconds 74659
The driver timed out an iSCSI
processor operation and is
aborting the operation. 933 #%d: QLTimer: Abort pTpb=%p, Type %x, Timeout 0x%x
DrvCount 0x%x, DdbIndex 0x%x 74661
The driver timed out an iSCSI
processor mailbox command. 935 #%d: QLReadyTimer: MBOX_CMD %04x %04x %04x %04x
%04x %04x %04x %04x timed out 74663
The driver timed out while
attempting to reconnect with the
iSNS. 937 #%d: QLReadyTimer: QLiSNSReenable failed 74665
Driver detected an error that
requires iSCSI FW to be restarted 977 #%d: QLProcessSystemError: Restart RISC 74705
iScsi FW failed to initialize 1018 #%d: QLInitializeFW: MBOX_CMD_INITIALIZE_FIRMWARE failed
%04x %04x %04x %04x %04x %04x 74746
The driver’s initiator database is
full. The driver is capable of 1056 #%d: QLUpdateInitiatorData: No more room in Initiator Database 74784
storing 1024 iSCSI initiators in
its database. Use the CLI or GUI
to remove unwanted/unused
iSCSI initiators.
The driver’s target database is
full. Use the CLI or GUI to remove
unwanted/unused iSCSI targets. 1072 #%d: QLSetTargetData: No more room in Target Database 74800
Fibre Channel driver
Table 28 (page 125) lists error log messages common to both Fibre Channel ports, 1 (FC1) and 2
(FC2). Log messages beginning with #0 apply to Fibre Channel port 1 (FC1), and log messages
beginning with #1 apply to Fibre Channel port 2 (FC2).
Table 28 FC driver—Error log messages
Description No. Log message ID
The FC processor received a
SCSI command for an unknown 87 #%d: QLUtmReceiveIo: Path invalid/FW No resource count
%x 106583
target path or has run out of
resources to execute additional
commands.
The FC processor was disabled
by an IOCTL request to the
driver. 93 #%d: QLIoctlEnable: Adapter disabled 106589
The FC processor firmware
failed initialization. The request 94 #%d: QLIoctlEnable: Initialize FW error 106590
to initialize was received by the
driver in an IOCTL request.
The FC processor failed the
external loopback test. 96 #%d: QLIoctlRunDiag: Diagnostic loopback command failed
%x %x %x %x 106592
Error log messages 125