HP IP Distance Gateway User Manual
Page 45

2.
Enter your user name and password. For example:
User (172.17.137.190:(none)): ftp331 Guest login ok, type your name
as password.Password: ftp230 Guest login ok, access restrictions
apply.
3.
At the ftp prompt, enter bin to set the binary mode. For example:
ftp> bin200 Type set to I.
4.
Issue the put command to transfer the firmware image file from the workstation to the mpx110.
For example:
ftp> put mpx110-2_0_3_2.bin200 PORT command successful.150 Opening
BINARY mode data connection formpx110-2_0_3_2.bin.226 Transfer
complete.ftp: 4822816 bytes sent in 0.41Seconds 11878.86Kbytes/sec.
5.
Enter quit.
The firmware image has been transferred to the mpx110.
6.
Log in to the mpx110 as an administrator:
(none) login: guest
Password: password
The following appears:
Command Line Interface (CLI)
mpx110 #> admin start
Password: config
mpx110 (admin) #>
7.
Enter the following command from the gateway:
image unpack mpx110-2_0_3_2.bin
The following prompt appears:
Unpack Completed. Please reboot the system for FW to take effect.
8.
Enter reboot.
9.
Enter y to reboot the system.
Firmware upgrades
45