HP IP Distance Gateway - Manual (Page 88)

FRU command
Saves and restores the mpx110 configuration.
Admin session Authority
fru Syntax
restore
fru restore requires that the user first ftp the .tar file containing the desired
configuration to the mpx110. When this command is issued it prompts the user for the
Parameters
restore level. The user has the option of fully restoring the mpx110’s configuration (all
configuration parameters and LUN mappings) or restoring only the LUN mappings. The
restored configuration do not take effect until the mpx110 is rebooted.
save
fru save creates a .tar file containing the mpx110’s persistent data, configuration
and LUN mappings, storing the file in the mpx110's /var/ftp directory. The user must
then FTP the .bin file from the mpx110.
The following is an example of the fru restore command: Examples
mpx110 (admin) #> fru restore
A list of attributes with formatting and current values will
follow. Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or 'Q'
and the ENTER key to do so.
Type of restore (0=full, 1=mappings only) [full] FRU restore completed. Please reboot the
system for configuration to take effect.
The following is an example of the fru save command:
mpx110 (admin) #> fru saveFRU save completed. Configuration File
is HP_StorageWorks_mpx110_fru.bin. Please use FTP to extract
the file out from the System.
88 Command-line interface