3 installation and upgrades, Verifying mpx110 requirements – HP IP Distance Gateway User Manual
Page 33

3 Installation and upgrades
This chapter contains the information needed to install, configure, and upgrade the mpx110.
Verifying mpx110 requirements
Obtain the following (one of each, unless otherwise noted) for the local and remote site:
•
HP IP Distance Gateway (mpx110), Part Number: AG680A
•
HP P9000 or P6000 Continuous Access software or P10000/3PAR Remote Copy software
EVA4400/4400 with embedded switch, EVA4000/4100/6000/6100/8000/8100,
EVA6400/8400, P6350/P6300/P6550/P6500, or
P9500/XP24000/20000/12000/10000 storage system or P10000/3PAR V-Class, F-Class,
T-Class storage systems
•
FC fabrics consisting of HP B-series, C-series, or H-series switches
•
Cat 5e network cable, two per site
•
Optical SFPs and FC cables, two per site
Additional optional equipment (one of each, unless otherwise noted) for the local and remote site:
•
HP IP Distance Gateway Upgrade (mpx110 for redundancy), Part Number: AG681A
•
Optical SFPs and FC cables, two per site
NOTE:
For the latest information about the minimum system requirements, see the HP IP Distance
Gateway release notes, available at
. Under Storage, select
Storage Networking, and then under Routers/Gateways/Multiplexers, select HP IP Distance
Gateway.
Verifying mpx110 requirements
33