HP IP Distance Gateway - Manual (Page 86)

FCIP route and specifying an FC and GE port pair take precedence over any previous configuration
for the port pair (FC/GE).
Admin session Authority
fciproute Syntax
add
Configures a new FCIP route
Parameters
mod
Modifies an existing FCIP route
rm
Removes an existing FCIP route
The following is an example of the fciproute add command: Examples
mpx239 (admin) #> fciproute add
A list of attributes with formatting and current values will
follow. Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or 'Q'
and the ENTER key to do so.
WARNING: The following command might cause a loss of connections to
both GE ports.
Configuring FCIP Route: 1
— — — — — — — — — — — — — —
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled]
FC Port (1=FC1, 2=FC2, ...) [FC1]
GE Port (1=GE1, 2=GE2, ...) [GE1]
IP Address (IPv4 or IPv6; 0=IPv6 Link Local) [0.0.0.0 ]
44.44.1.239
Subnet Mask [0.0.0.0 ] 255.255.0.0
Gateway IP Address [0.0.0.0 ]
Remote IP Address [0.0.0.0 ] 44.44.1.240
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal]
TCP Window Size (0=8KB, 1=16KB, 2=32KB) [32768]
Window Scaling (0=Enable, 1=Disable)[Disabled] 0
Window Scaling Factor (Min=0, Max=7) [0] 7
TCP Port No. (Min=1024, Max=65535) [3225]
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb) [Auto]
Bandwidth, Mbit/sec (Min=1, Max=1000) [1000] 155
VLAN (0=Enable, 1=Disable) [Disabled]
FCIP SW Compression (0=Enable, 1=Disable) [Disabled]
VLAN (0=Enable, 1=Disable) [Disabled]
FCIP SW Compression (0=Enable, 1=Disable) [Disabled]
All attribute values for FCIP Route 1 will now be saved.
mpx239 (admin) #>
The following is an example of the fciproute modify command:
mpx239 (admin) #> fciproute mod
Enter a new value or simply press the ENTER key to accept the
current value.
If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
WARNING: The following command might cause a loss of
connections to both GE ports.
Route FC Port ID GE Port ID
- — — — — — — — — — — — — —
1 FC1 GE1
2 FC2 GE2
Please select a FCIP route from the list above ('q' to quit):
2
Configuring FCIP Route: 2
- — — — — — — — — — — — — —
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
IP Address (IPv4 or IPv6; 0=IPv6 Link Local)
[2000:33::32:2:239]
IPv6 Default Router [::]
86 Command-line interface