HP IP Distance Gateway User Manual
Page 60
–
IPv6 Default Router—If the Auto button is not selected, select to configure the IP
default router.
–
IPv6 Local Link—If the Auto button is not selected, select to configure the IP local link
address.
–
Set IP Address—Save any IP address changes.
Figure 36 Management Information
•
Network Time Protocol (NTP) Server Information—Use to configure NTP settings.
Click the
icon to access the following settings (
):
◦
System Time—The current date and time set on the gateway.
◦
NTP Server radio buttons—Disable or enable the use of NTP servers to set the gateway’s
date and time.
◦
NTP Server 1—IP address of the first NTP server to be queried by the gateway when
setting its time and date.
◦
NTP Server 2—IP address of the second NTP server to be queried by the gateway when
setting its time and date. This server is used only if the first NTP server did not respond.
◦
NTP Server 3—IP address of the third NTP server to be queried.
◦
Set NTP Address—Saves changes made to the NTP server IP addresses.
60
Using the HP mpx Manager utility