Set snmp command, Set system command, Set snmp command set system command – HP IP Distance Gateway User Manual
Page 98

Set SNMP command
Configures general SNMP properties. It also provides for configuration of up to eight trap
destinations.
Admin session
Authority
set snmp
Syntax
trap_destinations
Sets the number of the trap destinations to be configured for SNMP
Parameter
The following is an example of the set snmp command:
mpx110 (admin) #> set snmp A list of attributes with formatting and current
values will
Examples
follow. Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or 'Q'
and the ENTER key to do so.
Configuring SNMP:
-----------------
Read Community [ ] Public
Trap Community [ ] Private
System Location [ ]
System Contact [ ]
Authentication Traps (0=Enable, 1=Disable) [Disabled]
All attribute values that have been changed will now be saved
The following is an example of configuring an SNMP trap destination:
mpx239 (admin) #> set snmp trap_destinationsA list of attributes with formatting and current
values will
follow. Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or 'Q'
and the ENTER key to do so.Configuring SNMP Trap Destination 1 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled] 0
IP Address (IPv4 or IPv6)[0.0.0.0] 10.6.6.28
Destination Port [0]
Trap Version [0]
Configuring SNMP Trap Destination 2 :
—-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 3 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 4 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 5 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 6 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 7 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 8 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
All attribute values that have been changed will now be
saved
mpx239 (admin) #>
Set System command
Configures general mpx110 parameters.
Admin session
Authority
set system
Syntax
port_num
Sets the number of the iSCSI port to be configured for iSNS
Parameter
The following is an example of the set system command:
Example
98
Command-line interface