HP IP Distance Gateway - Manual (Page 85)

Beacon command
Enables or disables flashing the Heartbeat and System Fault LEDs. The Heartbeat and System Fault
LEDs are flashed synchronously (they are turned on and off together). No other LEDs are affected.
None Authority
beacon Syntax
on
Turns on the mpx110 beacon
Parameters
off
Turns off the mpx110 beacon
mpx110 #> beacon on Example
Clear command
Allows you to remove all entries from the mpx110’s log file and/or reset the Fibre Channel and
iSCSI statistic counters.
Admin session Authority
clear Syntax
logs
Clears all entries from log file
Parameters
stats
Resets statistic counters
The following is an example of the clear command: Examples
mpx110 #>clear logs
mpx110 #>clear stats
Date command
Displays or sets the date and time. To set the date and time, the information string must be provided
in this format MMDDhhmmCCYY. The new date and time take effect immediately.
Admin session Authority
date
[MMDDhhmmCCYY]
Syntax
[MMDDhhmmCCYY]
Specifies the date—This requires an Admin session. If you omit [MMDDhhmmCCYY], the
current date appears, which does not require an Admin session.
Parameter
NTP must be disabled to set the time with the date command. Notes
See Set command (page 94) for information about NTP.
The following is an example of the date command: Example
mpx110 (admin) #> date 010314282006
Tue Jan 3 14:28:00 2006
mpx110 (admin) #> date
Tue Jan 3 14:28:14 2006
FcipRoute command
The fciproute command configures a new FCIP route and modifies or deletes an existing FCIP
route. Each FCIP route requires a dedicated FC and Gigabit Ethernet (GbE) port. Configuring an
Commands 85