Fibre channel driver – HP IP Distance Gateway User Manual
Page 130
Table 31 iSCSI driver—Fatal log messages (continued)
Description
No.
Log message
ID
iSCSI processor reboot failed.
978
#%d: QLProcessSystemError: RebootHba failed
70610
iSCSI processor NVRAM invalid
(checksum error).
1152
#%d: QLConfigChip: invalid NVRAM
70784
iSCSI FLASH (NVRAM)
command failed
1203
#%d: QLStartFw: MBOX_CMD_SET_FLASH failed %x
70835
iSCSI firmware loader invalid
state
1204
#%d: QLStartFw: Invalid Fw loader state 0x%x
70836
iSCSI failed to load firmware in
time allotted
1205
#%d: QLStartFw: Load Fw loader timeout
70837
Fibre Channel driver
lists fatal log messages common to both Fibre Channel ports, 1 (FC1) and 2
(FC2). Log messages beginning with #0 apply to Fibre Channel port 1 (FC1), and log messages
beginning with #1 apply to Fibre Channel port 2 (FC2).
Table 32 FC driver—Fatal log messages
Description
No.
Log message
ID
FC1 processor SRAM test
failed.
19
#%d: qlutm_init: Diagnostic failed, port 1 invalid SRAM
102419
FC1 processor POST failed.
20
#%d: qlutm_init: Diagnostic failed, port 1 POST failed
102420
FC2 processor SRAM test
failed.
21
#%d: qlutm_init: Diagnostic failed, port 2 invalid SRAM
102421
FC2 processor POST failed.
22
#%d: qlutm_init: Diagnostic failed, port 2 POST failed
102422
FC processor failed to return
diagnostic results.
23
#%d: qlutm_init: Failed to return diagnostic result to Bridge
102423
FC processor failed reset.
256
#%d: QLInitializeAdapter: Reset ISP failed
102656
FC processor firmware load
failed.
257
#%d: QLInitializeAdapter: Load RISC code failed
102657
FC processor receive
sequencer code load failed.
258
#%d: QLInitializeAdapter: Load ISP2322 receive sequencer
code failed
102658
FC processor transmit
sequencer code load failed.
259
#%d: QLInitializeAdapter: Load ISP2322 transmit sequencer
code failed
102659
FC processor firmware
checksum failed.
262
#%d: QLInitializeAdapter: Verify Checksum command failed
(%x)
102662
FC processor firmware
initialization failed.
280
#%d: QLInitializeFW: FAILED
102680
FC processor paused due to
internal parity error.
288
#%d: QLInterruptServiceRoutine: Risc pause %x with parity error
hccr %x, Disable adapter
102688
FC processor returned an
invalid interrupt status.
289
#%d: QLInterruptServiceRoutine: Invalid interrupt status: %x
102689
FC processor invalid
interrupt status
291
#%d: QLFcipInterruptServiceRoutine: Risc pause %x with parity
error hccr %x, Disable adapter
10691
FC processor paused due to
RAM parity error
292
#%d: QLFcipInterruptServiceRoutine: Invalid interrupt status: %x
10692
130 Log data