HP EML E-series Tape Libraries - Manual (Page 97)

11558
26
6. Close the back doors of the library.
7. Make sure that the tape drive has the latest firmware for correct operation. If necessary, upgrade the
drive firmware using the Command View TL firmware upgrade wizard or the Interface Manager’s
Command Line Interface. See the HP StorageWorks Interface Manager and Command View TL
User’s Guide for detailed procedures on upgrading drive firmware.
Load port magazine
Part number 375813-001
Location
Inside the load port door on the right side of the base module,
tape drive expansion module, and capacity expansion module
Characteristics One column, five slots
Function Holding tape cartridges for placement into library
Illustration
gl01026
Removing a load port magazine
1. On the OCP, select the Operations > Unlock Load Ports command. All load port doors open.
2. Fully open the load port door.
3. Grab the handle and pull the magazine out of the load port along its track to remove it from the
library.
Enterprise Modular Library E-Series 97