HP EML E-series Tape Libraries - Manual (Page 100)

Preparing the library for long-distance relocation
1. Use your application software to remove all tape cartridges from the tape drives.
2. Remove all tape cartridges from the library slots.
3. Carefully pack all tape cartridges for shipment.
4. Install the shipping straps on the robot.
5. Push the yellow gear lock up to prevent movement of the reduction gear.
10954
2
1
1 Shipping straps
2 Yellow gear lock
6. Disconnect all cables from hosts, switches, or local networks and pack them with other library
accessories.
7. If the library needs to be crated, go to the next section.
Repacking the library
Use this section if you need to:
• Ship the library to the new site.
• Transport the library by forklift or similar means.
WARNING!
Use at least two people to perform any steps that involve lifting or guiding the library.
1. Put the library on a shock pallet. If your library was delivered in a rack, use the shock pallet that
came with the library. If your library was not delivered in a rack, use your own shock pallet.
a. Raise the library support feet.
b. With the help of at least one person, roll the library to a position in front of the pallet ramp.
100 Moving the library